ProForm PFB38031 - Manual (Page 7)

7
6. Insert the Backrest Bracket (10) through the slot
in the Bench Frame (1) and under the Adjustment
Lever (8).
Make sure that the M10 x 62mm Flat
Head Screw (77) is in a notch under the
Backrest Bracket.
Lubricate an M10 x 155mm Button Bolt (85) with
grease. Attach the Backrest Tubes (6) to the
Bench Frame (1) with the Bolt, two M10 Washers
(67), and an M10 Nylon Locknut (69).
Do not
overtighten the Locknut; the Backrest Tubes
must be able to pivot easily.
8. Attach the Seat (13) to the Bench Frame (1) with
an M6 x 63mm Screw (65), an M6 Washer (68),
and two M6 x 16mm Screws (63).
7. Attach the Backrest (12) to the Backrest Tubes
(6) with four M6 x 38mm Screws (64) and four M6
Washers (68).
Tighten the six M10 Nylon Locknuts (69) used
in step 5.
6
7
8
1
85
Lubricate
67
10
77
67
6
8
69
12
68
64
68
63
65
68
13
1
64
6