Poulan Pro 1420 - Manual (Page 11)

11
LIMBING
S
Limb a tree only after it is cut down.
S Leave the larger limbs underneath the
felled tree to support the tree as you
work.
S Start at the base of the felled tree and
work toward the top, cutting branches
and limbs. Remove small limbs with
one cut.
S Keep the tree between you and the
chain.
S Remove larger branches with the cut-
ting techniques described in BUCKING
WITHOUT A SUPPORT.
S Always use an overcut to cut small
and freely hanging limbs. Undercut-
ting could cause limbs to fall and pinch
the saw.
PRUNING
WARNING: Limit pruning to limbs
shoulder height or below. Do not cut if
branches are higher than your shoulder.
Get a professional to do the job.
S
Make your first cut 1/3 of the way
through the bottom of the limb. This cut
will make the limb sag so that it falls
easily on the second cut.
S
Next make a second cut all the way
through the limb.
S
Finish the pruning operation by using
an overcut so that the stump of the
limb protrudes 1 to 2 inches from the
trunk of the tree.
First cut
1/3 of way
Second cut
3rd cut 1 to 2 in.
from trunk of tree
MAINTENANCE
CUSTOMER RESPONSIBILITIES
Fill in dates as you complete
regular service
Check for damaged/worn parts
Check for loose fasteners/parts
Check chain tension
Check chain sharpness
Check guide bar
Inspect and clean unit & labels
Before
Use
After
Use
Every
15 min.
Service
Dates
n
n
n
n
n
n
Check bar and chain oil level
Clean guide bar groove
n
n
n
WARNING: Disconnect power source before performing maintenance.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover
items that have been subjected to oper-
ator abuse or negligence. To receive full
value from the warranty, the operator
must maintain unit as instruct- ed in this
manual. Various adjustments will need
to be made periodically to properly
maintain your unit. Improper mainte-
nance may cause damage to the unit
and possible injury to the operator or by-
standers.
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for
replacement of damaged or worn parts.
NOTE: It is normal for a small amount of
oil to appear under the saw after motor
stops. Do not confuse this with a leaking
oil tank.
S
Trigger Switch -- Ensure the trigger
switch functions properly by squeez-
ing and holding the trigger switch.
Make sure motor starts and stops.