Philips CCZ191AT - Manual (Page 10)

10 Automatic Channel Setup
Although the TV/VCR may automatically memorize the channels
you receive when you turn it on for the first time, you may set up
channels again by following the steps below.
1
Press the MENU button.
TO ADJUST PRESS { / B
> INPUT
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION CABLE
2
Press the PLAY/▲ button or the STOP/▼ button to select
INPUT. Press the REW(ind)/{ button or the F.FWD/ B
button until ANTENNA or CABLE (whichever you have)
appears beside INPUT.
3
Press the STOP/▼ button repeatedly to select PRIM.
SETUP, then press the F.FWD/ B button.
PRIMARY SETUP
> SELECT LANGUAGE
AUTO PROGRAMMING
CH MEMORY REVIEW
VOLUME BAR
[ON]
SET CLOCK
SELECT KL CHOOSE B
TO END PRESS EXIT
4
Press the PLAY/▲ button or the STOP/▼ button to select
AUTO PROGRAMMING, then press the F.FWD/ B but-
ton. AUTO PROGRAMMING MEMORIZED CH ... will appear
on-screen. The TV/VCR will memorize all available channels.
• Line Input mode will always be
stored in the TV/VCR’s memory as
channel 00. You cannot delete it.
• You cannot program channels when
the TV/VCR is on channel 00 (A/V
INPUT will appear beside INPUT at
step 2). Select ANTENNA or CABLE
at step 2.
Helpful Hints
5
Wait for a few minutes. When setup is complete, CHANNELS
ARE SET will appear on-screen. Then the programming of the
lowest channel number placed in the TV/VCR’s memory will
appear on-screen. Now, when you press the CHANNEL ▲/▼ but-
tons, you will scan only through channels you receive.
5 Wait for the TV/VCR to set up
channels.
TO ADJUST PRESS { / B
> INPUT
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION CABLE
REW
PLAY
POWER
SPEED MUTE
SLEEP
ALT.CH
CHANNEL
VOLUME
REC/OTR
STATUS/EXIT
MEMORY PAUSE/STILL
MENU CLEAR TRACKING
STOP
F.FWD
o
o o
o
p
p
o
p
o
p
1 2 3
4 5 6
7 8 9
0 +100
1
2-4
CCZ191/CCZ191comb.QX33 4/6/99 6:42 PM Page 10