beautypg.com

Service and adjustments – Poulan 530163414 User Manual

Page 8

background image

8

SERVICE AND ADJUSTMENTS

REPLACING THE LINE

Pre--wound spools offer the most convenient
method for replacing line and ensuring opti-
mum performance.

S

Replacement spools are color--coded to
ensure use of the correct spool with your
unit. Be sure to use the same color spool as
the existing spool.

NOTE:

Always clear dirt and debris from

cutting head components when performing
any type of maintenance.

S

Hold spool and unscrew cap by turning in
the direction shown on top of the cap.

S

Remove line guide ring and spool.

NOTE:

When removing and/or installing spool,

ensure dust cup remains installed over shaft.

Use a pre--wound spool or refill spool with
line. If using a pre--wound spool, remove tape
strip from line and spool.

REFILLING THE SPOOL WITH LINE

WARNING:

Use only 0.080” (2 mm)

diameter round line. Other sizes and shapes
of line will not advance properly and will result in
improper cutting head function or can cause se-
rious injury. Do not use other materials such as
wire, string, rope, etc. Wire can break off during
cutting and become a dangerous missile that
can cause serious injury.
1.

Cut a length of 30 feet of .080” (2 mm) di-
ameter round Poulan PRO

"

brand line.

Feed line in
direction
shown on
spool.

Spool

2.

Insert one end of line into center cavity of
empty spool. Ensure line will feed into
spool in the direction shown on the spool
(counterclockwise).

3.

Continue feeding line into spool, leaving 4

-- 6 inches (10 -- 15 cm) unwound from

center of spool.

INSTALLING SPOOL WITH LINE

1.

Install replacement spool.

2.

Thread line through line guide ring.

Line through guide ring

Replacement Spool

Slot

3.

Rest guide ring on spool and place line in
slot. Allow line to extend 4 -- 6 inches (10

-- 15 cm) from center of spool.

4.

Ensure line remains in slot while screw-
ing cap on to the shaft. Only tighten cap
hand tight!

CARBURETOR ADJUSTMENT

WARNING:

Keep others away when

making idle speed adjustments. The trimmer
head will be spinning during this procedure.
Wear your protective equipment and observe
all safety precautions.
The carburetor has been carefully set at the
factory. Adjustments may be necessary if you
notice any of the following conditions:

S

Engine will not idle when the throttle is
released.

Make adjustments with the unit supported so
the cutting attachment is off the ground and
will not make contact with any object. Hold
the unit by hand while running and making ad-
justments. Keep all parts of your body away
from the cutting attachment and muffler.

Idle Speed Adjustment

Allow engine to idle. Adjust speed until engine
runs without stalling (idle speed too slow).

S

Turn idle

speed screw clockwise to

increase engine speed if engine stalls or
dies.

S

Turn idle speed screw counterclockwise to
decrease engine speed.

Idle Speed

Screw

Air Filter
Cover

If you require further assistance or are unsure
about performing this procedure, contact an
authorized

service

dealer

or

call

1--800--554--6723.

This manual is related to the following products: