Control guide, Main unit, Display – Panasonic SCHT56 User Manual
Page 5
5
RQTX0175
Standby indicator [^]
When the unit is connected to the AC power supply, this
indicator lights up in standby mode and goes out when the
unit is turned on.
[8, POWER]
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a small
amount of power.
Main unit
[-MENU,
―SETUP, RETURN]
For entering menus and setup to make various settings.
For returning to previous menus.
•
•
[TUNE, 2 / 3, 1 / 4]
For tuning the radio and selecting menu or setup items.
[SETUP MIC] jack
For calibration microphone.
[ENTER]
Used during menu or setup operations.
[VOLUME]
Volume control.
[ ] Headphone jack
Plug type:
Ø
3.5 mm (
1
/
8
") stereo
Sound does not come from the speakers if you connect
headphones.
Avoid listening for prolonged periods of time to prevent
hearing damage.
•
•
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
Remote control signal sensor
[INPUT SELECTOR, <, >]
For selecting input.
10
[AUTO SPEAKER SETUP]
Flashes during Auto Speaker Setup. Lights when the setup
finishes.
10
Control guide
Control guide
Display
[ft, kHz, MHz]
Distance and frequency unit indicators
ft: feet (speaker distance)
kHz: AM, or PCM sampling frequency
MHz: FM
[TUNED, ST, MONO]
Radio indicators
TUNED: A station is tuned
ST: A stereo FM broadcast is tuned
MONO: You have switched to monaural mode to improve
reception
[SLEEP]
Sleep timer indicator.
[PCM, C.FOCUS]
PCM: Lights when the PCMFIX mode is set
C.FOCUS: Appears when you are using Center Focus
[SFC, 2CH MIX]
SFC: Appears when you are using an SFC mode
2CH MIX: Appears when you are listening to a multi-channel
source with headphones
General display
Shows the input mode, radio frequency and other general
information.
[DIGITAL INPUT]
Lights when input is digital.
1
2
3
4
5
6
[ % DIGITAL, DTS, % PL
ΙΙ]
Lights to indicate the source's input signal and decoding
format used.
%
DIGITAL: Dolby Digital sources
DTS: DTS sources
%
PL
ΙΙ: Dolby Pro Logic ΙΙ decoder is being used
7
8
[M]
Flashes or lights during presetting.
9
10
[W]
Lights when you are using the digital transmitter (
➡
page 7).
Flashes when there is no link between the main unit and
the wireless system (For details, refer to the operating
instructions for SH-FX67).
1
2
3
4
5
6
7
9
8
10
TUNED
MONO
SLEEP
PCM
ST
kHz
ft
MHz
DIGITAL DTS
2CH MIX
SFC
M
C.FOCUS
DIGITAL INPUT
PL
W
SC-HT56P_MP (RQTX0175-2P).indb 5
9/19/2008 12:27:59 PM