Identification of safety symbols, Safety rules, Warning – Poulan Pro PP258TP User Manual
Page 4
4
IDENTIFICATION OF SAFETY SYMBOLS
WARNING:
Fire hazard. Never mix, pour, or store gasoline or
use the unit near a flame or sparks (including smoking, open flames, or
work that can cause sparks).
Use unleaded gasoline and two--stroke oil mixed at a ratio of
40:1 (2.5%).
Always stop unit and disconnect spark plug before clean-
ing or servicing.
SAFETY RULES
WARNING:
Always disconnect spark
plug wire and place wire where it cannot contact
spark plug to prevent accidental starting when
setting up, transporting, adjusting or making re-
pairs except carburetor adjustments.
Because a pruner is a high-speed wood-cutting
tool, special safety precautions must be ob-
served to reduce the risk of accidents. Careless
or improper use of this tool can cause serious or
even fatal injury.
PLAN AHEAD
S
Read this manual carefully until you
completely understand and can follow all
safety rules, precautions, and operating
instructions before attempting to use the unit.
S
Restrict the use of your pruner to adult users
who understand and can follow safety rules,
precautions, and operating instructions found
on the unit and in this manual.
SAFETY INFORMATION
ON THE UNIT
INSTRUCTION
MANUAL
S
Keep all parts of your body away from the
chain when the engine is running.
S
Do not handle or operate a pruner when you
are fatigued, ill, or upset, or if you have taken
alcohol, drugs, or medication. You must be in
good physical condition and mentally alert. If
you have any condition that might be
aggravated by strenuous work, check with
doctor before operating a pruner.
If situations occur which are not covered in
this manual, use care and good judgment. If
you need assistance, contact your authorized
service dealer or call 1-800-554-6723.
OPERATE YOUR PRUNER SAFELY
S
Operate the pruner only in a well-ventilated
outdoor area.
S
Do not use a pruner to cut down trees or any
portion of the tree trunk.
S
Only use for pruning limbs or branches
overhead not greater than 6 inches (15 cm)
in diameter.
S
Do not cut small brush and saplings with the
pruner. Slender matter may catch in the
chain and be whipped toward you, pulling
you off balance.
S
Make sure the chain will not make contact
with any object while starting the engine.
Never try to start the unit when the guide
bar is in a cut.
S
Do not put pressure on the pruner at the end
of the cut. Applying pressure can cause you
to lose control when the cut is completed.
S
Do not run the unit at high speed when not
pruning.
S
If you strike or become entangled with a
foreign object, stop the engine immediately
and check for damage. Have any damage
repaired by an authorized service dealer
before attempting further operations.
S
Do not operate a pruner that is damaged,
improperly adjusted, or not completely and
securely assembled. Always replace bar
and chain immediately if it becomes
damaged, broken or is otherwise removed.
S
Always stop the unit when work is delayed
or when walking from one cutting location to
another. Stop the engine before setting the
unit down.
S
Use only in daylight or good artificial light.
S
Use only for jobs explained in this manual
(or manuals for optional attachments).