Philips SBC RU 430-1 - Manual (Page 4)

RU240- page 4
4
3 Immediately press to stop the search.
If you missed the correct code because the search went too far, switch
the equipment back on, then press
(down) to send the previous
code again. Press (down) repeatedly until the equipment switches
off again.
4 Once you've found the correct code, press to lock it in memory.
The green LED blinks twice.
That's it! Now, switch the equipment manually on again, then press a
few keys on the remote to check that the equipment responds correctly.
In the rare instance that it doesn't, try again from step 1 to find a better
code.
Note that code! To save time if you ever need to setup again, make a
note of the correct code inside the battery case and in the back of this
booklet. In case you have forgotten to note the code you can still 'read
out' the code from the remote. Here's how:
1 Make sure you've selected the right mode (with
). Then press
and release and at the same time; the
green LED lights up.
2 Press . The green LED goes out.
3 Press and count the number of times the green LED blinks. This
is the first digit of the 3-digit code. (No blinks means the digit is
zero.)
Press
and count the number of blinks for the second digit.
Press and count the number of blinks for the third digit.
ADVANCED TIPS AND TRICKS
TO CHANGE SAT MODE TO CONTROL A SECOND TV
The SAT mode on this remote is used to control additional equipment. It
is factory preset to control a satellite receiver, but you can change it to
control a second TV, for example.
Before you start, press to select SAT, and make sure the second
TV is switched on.
1 Press and hold
and at the same time -for about 3 seconds-
until the green LED lights up.
2 On the keypad, enter 992.
3 Press
to select TV mode, then press any key except once
more. That's it!
Don't forget you now need to setup the remote to operate this second
TV - see Getting started.
TO CONTROL THE SECOND TV'S VOLUME
If you have installed a second TV under SAT mode, you can also control
that TV's volume when you are in VCR mode.
Before you start, press to select VCR.
1 Press and hold and at the same time until the green LED
lights up (about 3 seconds).
6 1
6 1
3
2
1
6 1
P
P
English