Storage – Poulan 530163727 User Manual

Page 16

Hub

Line in Notch

Line exit holes

Wind the line evenly and tightly onto the
spool. Wind in the direction of the arrows
found on the spool.

Push the lines into the notches, leaving 3
to 5 inches (7 -- 12 cm) unwound.

Insert the lines into the the exit holes in
the hub as shown in the illustration.

Align the notches with the line exit holes.

Push spool into hub until it snaps into
place.

10. Pull the lines extending outside of the hub

to release the lines from the notches.

BLADE REPLACEMENT

Refer to the ASSEMBLY section for blade re-
placement instructions and illustrations.

CARBURETOR ADJUSTMENT

WARNING:

Keep others away when

making idle speed adjustments. The trimmer
head, blade or any optional attachment will be
spinning during most of this procedure. Wear
your protective equipment and observe all
safety precautions.

After making adjust-

ments, the trimmer head, blade or any option-
al attachment must not move/spin at idle
speed.
The carburetor has been carefully set at the
factory. Adjustments may be necessary if you
notice any of the following conditions:

Engine will not idle when the throttle is
released.

The trimmer head, blade or optional
attachment moves/spins at idle.

Make adjustments with the unit supported so
the cutting attachment is off the ground and
will not make contact with any object. Hold
the unit by hand while running and making ad-
justments. Keep all parts of your body away
from the cutting attachment and muffler.

Idle Speed Adjustment

Allow engine to idle. Adjust speed until engine
runs without trimmer head, blade or optional
attachment moving or spinning (idle too fast)
or stalling (idle speed too slow).

Turn idle

speed screw clockwise to

increase engine speed if engine stalls or
dies.

Turn idle speed screw counterclockwise to
decrease engine speed if trimmer head,
blade or optional attachment moves or
spins at idle.

WARNING:

Recheck the idle speed

after each adjustment.

The trimmer head,

blade or optional attachment must not move
or spin at idle speed to avoid serious injury to
the operator or others.

Idle Speed

Screw

Air Filter
Cover

If you require further assistance or are unsure
about performing this procedure, contact an
authorized

service

dealer

call

1--800--554--6723.

STORAGE

WARNING:

Perform the following

steps after each use:

Allow engine to cool before storing or trans-
porting.

Store unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, etc.

Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.

Store unit and fuel well out of the reach of
children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if
it will not be used for 30 days or more.
If your unit is to be stored for a period of time:

Clean

the

entire

unit

before

lengthy

storage.

Store in a clean dry area.

Lightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA-
TION section of this manual, see message la-
beled IMPORTANT regarding the use of ga-
sohol in your engine.
Fuel stabilizer is an acceptable alternative in
minimizing the formation of fuel gum deposits
during storage. Add stabilizer to the gasoline
in the fuel tank or fuel storage container. Fol-
low the mix instructions found on stabilizer
container. Run engine at least 5 minutes after
adding stabilizer.

ENGINE

Remove spark plug and pour 1 teaspoon of
40:1, 2-cycle engine oil (air cooled) through
the spark plug opening. Slowly pull the
starter rope 8 to 10 times to distribute oil.

Replace spark plug with new one of recom-
mended type and heat range.

Clean air filter.