Polaroid DVP 500 - Manual (Page 11)

- 10 -
Connections
NOTE: We suggest using S-Video for higher quality pictures, you may also
use the standard composite video connection if your TV does not have an
S-Video input.
Component Video connection
1. Connect the COMPONENT VIDEO OUT jacks on the DVD Player to the
corresponding input jacks on the TV using a Y/Pb(Cb)/Pr(Cr) cable supplied.
2. Connect the Left and Right AUDIO OUT jacks of the DVD Player to the
audio left/right input jacks on the TV using the supplied audio cable.
Connecting To an Analog Amplifier
Connect the Left and Right AUDIO OUT jacks on the DVD Player to the
audio left and right input jacks on your amplifier, receiver or stereo system
using the supplied audio cable. The connection diagram is shown as below:
IMPORTANT:
If the video has component video inputs, connect the
component video outputs on the DVD Player to the corresponding input
jacks on your television. If you are using a Progressive Scan television or
projector, you must also change the DVD Player’s video mode by shifting the
switch from “Interlace” to “Progressive” on the rear panel.