ProForm C500 PFTL57105.2 - Manual (Page 9)

9
10. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the
walking belt (see page 22). To protect the floor or carpet, place a mat under the treadmill. If there are thin
sheets of clear plastic on the decals, remove them.
8. Lower the Uprights (92, 95) until the handrails are touch-
ing the floor.
See the lower drawing. Position the Uprights (92, 95) so
that the treadmill Frame (59) is centered between them.
See the upper drawing. Firmly tighten the four Upright
Bolts (80). Then, raise the Uprights back to the vertical
position.
92
92, 95
Handrail
59
95
Top View
8
80
9. Attach the Latch Assembly (82) to the Left Upright (92)
with the two Latch Screws (46); start both Latch
Screws before tightening either of them. Note: It may
be necessary to remove the Latch Screws from the Left
Upright before beginning this step.
46
92
82
9