Panasonic WV-CL920 - Manual (Page 27)

-28-
Important Notices:
1. The priority for the sync modes is as follows.
1. Multiplexed Vertical Drive (VD2) (Highest prior-
ity)
2. Line-lock (LL)
3. Color Composite Video or Blackburst Signal
(VBS)
4. B/W Composite Video or Composite Sync
Signal (VS)
5. Internal Sync (INT) (Lowest priority)
2. When the internal sync mode is to be used, select
INT. No gen-lock input signal should be supplied to
the Gen-lock Input Connector on the rear panel.
3. Whenever the multiplexed vertical drive pulse
(VD2) is supplied to the camera from an external
equipment such as a Matrix Switcher, the camera
sync mode is automatically switched to the VD2
mode.
4. When the VBS or VS gen-lock mode is to be used
select INT from this menu and supply the gen-lock
input signal to the Gen-lock Input Connector on the
rear panel.
5. The VBS gen-lock mode has a submenu for hori-
zontal and subcarrier phase adjustments. When
the cable length of the video output or the gen-lock
input is changed, the horizontal and subcarrier
phase must be re-adjusted.
6. Synchronization Setting (SYNC)
You can select internal sync mode (INT) or line-lock
mode (LL). Additionally, this model accepts the VBS
signal (color composite video or blackburst signal) and
VS signal (B/W composite video or composite sync sig-
nal). The VD2 signal (multiplexed vertical drive signal)
with the composite video output signal from external
equipment such as a Matrix Switcher is also accept-
able.
Whenever the VD2 signal is supplied to this camera, the
camera automatically switches to the VD2 sync mode.
1. Move the cursor to the SYNC parameter and select
line-lock(LL) or internal(INT).
2. Press .
If LL is selected, the SYNC menu appears. See
page 31 (If INT is selected, the synchronization
mode is automatically set to internal sync pulse,
and the menu is not displayed.)
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON (DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵