Toaster tx-208, Daily cleaning – Prince Castle TX-208 User Manual

Page 4

537-511revC

TOASTER

TX-208

Power On/Off Button

Press the On/Off Button to turn the unit off.

Remove the lower retaining bar from the release sheet and pull
the release sheet up thru the top of the unit. Remove the upper
retaining bar from the release sheet.

WARNING

Before performing any maintenance, press the power switch to the
OFF position. If the heater is above 450°F, the display will alternately
show “CCO

” and “O

”, and the conveyor belt will continue to run

approximately 45 minutes. When the unit has cooled sufficiently, the
display will go blank and the conveyor motor will turn off.

Unplug the power cord from the electrical receptacle.

CAUTION

This unit is not watertight. Do not clean with a water jet or jet spray.
Do not immerse the unit in water.

1. Turn the unit off and unplug the power cord from the electrical

receptacle.

2. Wipe all stainless parts and unit with a damp cloth. DO NOT use

a green scotch bright pad cleaner, ice or water.

If the heater is above 450°F, the
display will alternately show
“

” and “

”, and the convey-

or belt will continue to run approx-
imately 45 minutes. When the unit
has cooled sufficiently, the display
will go blank and the conveyor
motor will turn off.

Unplug the power cord from the
electrical outlet.

Remove the front cover by pulling up and off the unit.
Set the cover aside.

Front Cover

Lower Retaining Bar

Remove release sheet

Daily Cleaning

Loosen the thumbscrews
and remove the side panel.

Thumbscrews

To release tension on the conveyor belt,
press in and down on the roller.

General

•

As buns are toasted, they leave an oily residue buildup on the
conveyor belt and Teflon release sheet.

•

Over a period of time, the residue will form a slick coating where
buns make contact on the belt surface.

•

If this slick coating is not removed, the belt may not pull the buns
into the toaster or will not pull the buns completely through the
toaster, and the buns will burn.