Powermate Vantage PM0606750 - Manual (Page 2)

* 12 HP Yamaha OHV engine
* Cast-iron cylinder sleeve
* Low oil sensor
* Receptacles on control panel
* DIGITECH™ Digital Information Center
* 7 gallon metal fuel tank
* Portability Kit
A. 120 Volt GFCI Receptacle
Ground Fault Circuit Interrupter duplex receptacle is rated
so that a total of 20 amps may be drawn regardless of whether
both halves or just one receptacle is used. This receptacle may
be used along with other receptacles provided the generator is
not overloaded and total power drawn is kept within nameplate
ratings.
Ground Fault Circuit Interrupter
(Conforms to U.L 943, Class A and NEC requirements)
This device protects you against hazardous electrical shock
that may be caused if your body becomes a path through which
electricity travels to reach ground. This could happen when
you touch an appliance or cord that is “ live “ through faulty
mechanism, damp or worn insulation, etc.
B. 120/240 V, 30 Ampere Twistlock Receptacle
A maximum of 30 amps may be drawn from the 120/240
volt receptacle, provided it is the only receptacle used.
However, current must be limited to the nameplate rating. If the
120/240 volt receptacle is used along with the 120 volt
receptacle, the total load drawn must not exceed the nameplate
ratings.
C. Circuit Breakers
The receptacles are protected by an AC circuit breaker. If
the generator is overloaded or an external short circuit occurs,
the circuit breaker will trip. If this occurs, disconnect all
electrical loads and try to determine the cause of the problem
before attempting to use the generator again. If overloading
causes the circuit breaker to trip, reduce the load. NOTE:
Continuous tripping of the circuit breaker may cause
damage to generator or equipment. The circuit breaker may
be reset by pushing the button of the breaker.
D. Engine On/Off Switch
E. DIGITECH™ Digital Information Center
The DIGITECH™ Digital Information Center is a patented
feature available only on select Coleman® Powermate® Brand
generators.
At a glance, the user can instantly see how much of the
generator's output capacity is being used and how much power
remains available. The display also indicates the time since last
user reset and the total accumulated runtime of the generator.
Power Bar - This bargraph provides a quick visual indication of
the percentage of rated output currently being supplied.
% Load Indicator - This is a numeric version of the Power Bar.
Total Timer - This indicates the total number of hours the
generator has run since manufacture.
Maintenance Timer - This indicates the number of hours the
generator has run since the last user reset. This timer should
be reset after every oil change or any other maintenance task.
Follow the instructions in the engine owners manual for proper
engine maintenance intervals.
Reset Button - Pressing and holding this button will reset the
Maintenance Timer to 0 HRS.
2
English
CONTROL PANEL
MAJOR GENERATOR FEATURES