ParaBody 375101 - Manual (Page 10)

10
FIGURE 9
FIGURE 10
STEP 8
STEP 10
4
8
61
54 1/2” LOW HEIGHT
67 1/2 X 3”
• Insert two 1/2” FLANGE BEARINGS (61) into the
LEG CURL/EXTENSION (8).
• Assemble the LEG CURL/EXTENSION (8) to the LEG
SUPPORT (4) using one 1/2 X 3” (67) and one 1/2”
LOW HEIGHT LOCKNUT (54). (NOTE: Securely
tighten, then back nut off 1/4 turn to allow the LEG
CURL/EXTENSION (8) to rotate freely.)
• Assemble four 4 X 7” ROLLER PADS (20) to the LEG CURL/EXTENSION (8) as shown on FIGURE 9 using two 3/4 DIA. X 16” TUBES
(17) and four STARLOCK COLLARS (35).
• Assemble two 4 X 7” ROLLER PAD (20) to the tube on the BENCH FRAME (2) as shown on FIGURE 9 using two STARLOCK
COLLARS (35) as shown in FIGURE 10.
17
8
20
35