Pioneer Digital Speaker System For iPod XW-NAS3 - Manual (Page 18)

Additional information 06
18
En
Resetting the system
Use this procedure to reset all system settings
to the factory default.
• When performing reset, first disconnect all
components connected to this unit.
1 Switch the unit on.
2 Press and hold VOLUME – on the top
panel, and then press and hold  STANDBY/
ON for three seconds.
Power is set to standby mode.
The next time you switch on, all the system
settings
should be reset.
About iPod/iPhone
“Made for iPod” means that an electronic
accessory has been designed to connect
specifically to iPod and has been certified by
the developer to meet Apple performance
standards.
“Works with iPhone” means that an electronic
accessory has been designed to connect
specifically to iPhone and has been certified by
the developer to meet Apple performance
standards.
Apple is not responsible for the operation of
this device or its compliance with safety and
regulatory standards.
iPod is a trademark of Apple Inc., registered in
the U.S. and other countries. iPhone is a
trademark of Apple Inc.
Specifications
• Amplifier section
RMS Power Output:
Front Left/Right . . . . . . . . . . . . . . 15 W + 15 W
(1 kHz, 10 %, T.H.D., 8 Ω)
Subwoofer . . 30 W (100 Hz, 10 %, T.H.D., 4 Ω)
• Speaker section
Enclosure . . . Bass-reflex (magnetically shielded)
System . . . . . . . . . . . . . . . . . . . . . . . 2-way system
Speakers:
Subwoofer . . . . . . . . . . . . . . 10 cm (4 in.) cone
Fullrange . . . . . . . . . . . . . . . 5.2 cm (2 in.) cone
Frequency range . . . . . . . . . . . . . 50 Hz to 20 kHz
• Miscellaneous
Power requirements
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .AC 120 V/60 Hz
Power consumption . . . . . . . . . . . . . . . . . . . 30 W
In standby. . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W
Dimensions
. . . . . . . 420 mm (W) x 148 mm (H) x 210 mm (D)
(16
9
/ 16 in. (W) x 5
7
/ 8 in. (H) x 8
5
/ 16 in. (D))
Weight (without package) . . . . . . . 4.9 kg (10.8 lb)
• Accessories
Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Remote control holder. . . . . . . . . . . . . . . . . . . . . .1
Lithium battery (CR2025) . . . . . . . . . . . . . . . . . . .1
Power cord . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Cleaning cloth . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Operating instructions (This document)
Note
• Specifications and the design are subject
to possible modifications without notice,
due to improvements.
XW-NAS3_CUXJ.book 18 ページ ２００９年１２月２４日 木曜日 午後１時４７分