Palsonic TFTV935S - Manual (Page 13)

Connections (continued)
10
Connect a VCR
SCART Cable
21 -pin SCART
connector VCR
How to connect:
Connect the SCART Cable between the unit and the VCR.
To play VCR
1. Turn on your LCD TV, press SOURCE button on the remote
control.
2. Push ENTER (Up/Down) to select Scart2 AV and press ENTER to
confirm.
3. Turn on your VCR, insert a videotape and press the Play button.
Note:
The unit receives CVBS (VIDEO) signal and Y/C (S-VIDEO) signal from SCART2 interface.
When receiving Y/C signal, you need to select Scart 2 Y/C instead of Scart 2 AV in the source select menu.
Therefore, if you find that the colour is not properly displayed, please try to select Scart 2 Y/C.
To connect to external devices with AV terminals, you may use 2 I-pin Scart Converter to connect to SCART
interface on the unit, then please select Scart 2 AV and the unit receives CVBS (VIDEO) signal only.
Select Main Source
1. TV
2. Video
3. S-Video
4. SCART 1
5. SCART 2 AV
6. SCART 2 Y/C
7. YPbPr
8. D-Sub
9. HDMI
Rear of the VCR