Philips AZ 1560/00 - Manual (Page 14)

14
English
AZ 1560 /00
page
14
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound/power
– VOLUME not adjusted
• Adjust the VOLUME
– Headphones connected
• Disconnect headphones
– Mains lead not securely connected
• Connect AC mains lead properly
Severe radio hum or noise
–
Electrical interference: set too close to TV,
VCR or computer
• Increase the distance
Poor radio reception
–
Weak radio signal
• FM: Direct the FM telescopic aerial for
optimum reception
indication
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
The CD skips tracks
–
CD damaged or dirty
• Replace or clean CD
– SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
Poor cassette sound quality
–
Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
– Use of incompatible cassette types (METAL
or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
–
Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space.
indication
– CD-R(W) is blank or the disc is not finalised
• Use a finalised CD-R(W)
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.