Philips HP 4496 - Manual (Page 8)

Styling attachments (fig. 13 - 18)
• Always style small tresses of hair (2 - 3 cm or 1 inch thick).
• For good results, wind a tress around the styling attachment in a spiral
form. The full length of the tress will then be in contact with the hot rod.
• Fix the end of the tress with the clip and wind the hair around the rod
towards the head.
After 5 - 10 seconds open the clip and remove the barrel from the hair.
- With "Spirals" wind the tress following the spiral profile on the styling
attachment.
- With "Curls" wind the hair in straight.
- With the "Brush" a clip is not required as the teeth grip the hair.
• Important: Always ensure that the hair ends are wrapped smoothly
around the barrel of the attachment: this will avoid bent ends.
• You can divide the curls with your fingers to add volume. Especially with
Spirals this will give you a stunning hairstyle.
"Crimper/Straightener" (fig. 19 - 21)
• Take tresses of hair of max. 5 - 6 cm or 2 inches thick.
• The clip enables you to open and close the Crimper/Straightener, so that
you can style a tress of hair section by section.
• Always start crimping or straightening close to the head. Then
successively treat the lower sections.
• You may press the two parts of the Crimper/Straightener together by
using your fingers. (Do not touch the plates!)
• Keep the hair in the Crimper/Straightener for 5-10 seconds. Then open
the Crimper/Straightener to treat the next section of the same tress.
Ensure that there is an overlap!
After use
- After use remove the mains plug from the wall socket.
- Place the appliance with the stand downwards on a safe place and allow
it to cool down.
Replacing the mains cord
If the mains cord of this appliance is damaged, it must only be replaced by
Philips or their service representative, as special tools and/or parts are
required.
8