Philips HC8800 - Manual (Page 6)

Controls Installation
6
English
Environmental Information
All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
Headphone (figure 2)
9 Power On/Off – push the button to
switch the headphone on/off.
10 Power indication – lights up when in use.
When batteries are low, the power
indicator flashes, and you should recharge
the headphone for about 16 hours before
the next use.
11 Recharging indicator – lights up when
the recharge cable is connected between
the headphone and the FM transmitter.
Completely flat batteries will be fully
charged after about 16 hours.
12 Recharging input – connect the
recharge cable to the input, green
recharging LED on the transmitter’s front
must switch on, indicating that the
headphone is being recharged.
13 Tuning – press and hold the button for
about 1 second.The headphone
automatically tunes to the right transmission
frequency. If not, repeat this step.
14 Volume – adjust volume to your desired
listening level.
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK, use only Philips SBC CS030/05)
1 Make sure the adapter’s rated voltage
corresponds to the mains socket voltage.
2 Connect the DC connector of the AC/DC
adapter to the 12 Volt DC power input
connector located at the rear of the
transmitter.
3 Connect the 12 Volt/200 mA AC/DC
adapter to the mains socket.
– Always disconnect the AC/DC adapter if
the transmitter is not to be used for a
long period of time.
XP SBC HC 8800/00-1.1 03-08-2001 16:45 Pagina 6