Precision Power MaxxBass - Manual (Page 10)

WIRING CONFIGURATIONS
The MaxxBass ® Processor is recommended in two different
configurations.
1. Front Stereo Configuration
The figure below illustrates the wiring for a front stereo
configuration. One
MaxxBass ® Processor is used between the front
channel source and front speaker amplifier to increase the bass
response only on the front speakers.
Implementing MaxxBass ® on the front speakers will increase the
perceived bass response of these speakers down to 30-40Hz
providing a Virtual Subwoofer. The listener will achieve better bass
balance and imaging with a rear mounted subwoofer or trunk
mounted speakers with sufficient bass response.
Front speakers
with Virtual
Subwoofer TM
Subwoofer
Front Rear
Maxx
Bass
®
In-dash
CD Receiver
Power
Amplifiers
LR
LF
RR
RF
9