Pass Labs pre-amplifier - Manual (Page 10)

10 X0.2 Owner’s Manual
All figures obtained after 1 hour warmup, with regulated 120 VAC
power line. See manual notes about AC power line regulation.
Gain, Balanced 12 dB Bal in, Bal output
Gain, single-ended 12dB unbal in, unbal output
Freq. Response -3 dB @ 2 Hz
-3 dB at @ 100 kHz
Distortion @ 1KHZ < .1 % THD, typ .003% @ 2v
Maximum Output 20 volts rms bal out
7 volts rms unbal out
Output Impedance 200 ohms unbalanced
750 ohms balanced
Input Impedance 10K ohm unbalanced
20K ohm balanced
CMRR typ. -80 dB, 20 - 20kHz
Crosstalk typ. -90 dB, 20 - 20kHz
Output Noise floor < -110 dBV, 20 - 20kHz
Extl amp turn on 12 volts DC 50 mA continuous
Power Consumption 35 watts
Dimensions 17” W x 3.5”H x 13 “D each
Shipping Weight 70 pounds in packing carton,
3 units
For more information please contact:
Pass Laboratories Inc.
P.O. Box 219,
24449 Foresthill Rd.,
Foresthill, CA 95631
Tel: 530.367.3690
Fax: 530.369.2193
www.passlabs.com
© 2006 Pass Laboratories Inc.
X0.2 Specifications
“Pass”, “pass”, “Pass Labs”, “Pass Laboratories”, Supersymmetery”,
“Aleph”, and “Zen” and are all registered trademarks of Pass
Laboratories, Inc., and all rights thereto are protected by law.