Pyramid Car Audio PSV-40 - Manual (Page 6)

CONNECTIONS
Caution : Make all other connections before you connect the power
supply standard AC power.
1. Turn off the device requiring power.
2. Set the power supply's POWER switch to OFF.
3. Turn the sleeves of the red and black binding output posts counterclockwise to
expose the wire hole.
4. Insert the device's positive wire (usually red) into the red binding post's wire
hole, then tighten the binding post's sleeve to secure the wire in place.
5. Insert the device's negative wire (usually black) into the black binding post's
wire hole, then tighting the binding post's sleeve to secure the wire in place.
6. If you are using the banana plugs connection, insert the plugs into the
terminal's jack.
Warnings: To avoid damage to both the power supply and the device:
• Follow the correct polarity when connecting the power supply and the device.
• Do not let the ends of the positive and negative wires touch each other.
Note: The binding posts' wire holes can accommodate up to 16-
gauge wire.
7. Connect the power supply's AC cord to a standard 120V AC outlet.
4