Power, ground, and remote – Precision Power PC1400 User Manual
Page 11
9
POWER / GROUND and REMOTE
Once you have run both the power and ground wires, it's time
to connect the cables to the amplifier. Cut off excess wire and,
using wire strippers, strip the ends of the power and ground
cables approximately 1/4 inch. Locate the
PowerLock
power
and ground connector (supplied). With a small flat bladed screw
driver, loosen the screws before attempting to insert the cables.
Insert the wires into the appropriate hole, and tighten the
screws. Once the wires are secure, the
PowerLock
may be
plugged into the amplifier. The Power/Ground
PowerLock
will
accommodate 4 gauge wire for the
PC1400/PC1800
.
R e m o t e t u r n - o n
Your head unit should have a lead marked 'remote' or 'power
antenna' which will be used to turn on your amplifier. Extend
this lead through your vehicle along with your RCA signal wires.
Strip 1/4 inch of insulation off the wire and insert the end into
the center terminal of the 5-pin speaker/remote
PowerLock.
Power/Ground
PowerLock
Connect to Amplifier
Power wires
Fastening screws