Philips SBC SC 367 - Manual (Page 5)

3. POWER SUPPLY
5
SBC367page 5
Notes
– Both the transmitter and receiver have a
‘battery low’ indication. If the batteries are
low the unit beeps and the red POWER LED
starts flashing.
– To conserve batteries, connect the units to
the mains by using the enclosed mains
adapters.
– If batteries are installed and the mains
power adapters are connected, the units
operate on mains power. In the event of a
mains failure, the batteries will take over.
IMPORTANT
– Replace batteriesinside the transmitter with
original PHILIPS LR6 POWERLIFE batteries
only.
– Batteries inside the receiver are already
installed. Replace these batteries with
rechargeable NICAD (R6) batteries ONLY.
DO NOT INSTALL ANY OTHER TYPE OF
BATTERIES INSIDE THE RECEIVER!
English
4. OPERATION
OPERATION (fig. 4)
Transmitter
• Make sure the mains power adapter is
connected correctly, or batteries are
installed.
• Place the transmitter near the baby’s bed,
making sure that the microphone is placed
in the best position for picking up baby’s
sounds.
IMPORTANT!
Make sure that the transmitter is always out of
reach of the baby; never place the transmitter
inside baby’s bed or playpen!
• Select the VOICE mode using the mode
switch (fig. 1.6) .
– If sound is picked up by the built-in
microphone, the transmitter starts
transmitting automatically. The transmission
stops when no sound is picked up any
more. During transmission the green
TRANSMIT LED lights up.
– The transmitter also has a button for manual
transmission TALK (fig. 1.8) . This function
operates both during VOICE and OFF-mode.
For manual transmission:
• Keep the TALK button pressed and speak
into the microphone.
– The green TRANSMIT LED light up.
– Spoken sound is transmitted until the TALK
button is released.
Receiver
• Make sure that the mains power adapter is
correctly connected to the recharging base,
or that batteries are installed.
– If batteries are installed, the receiver uses
rechargeable battery power only in the
event of a mains failure, or when the unit is
not placed inside the standing base.
• Place the receiver inside the recharging
base, near to the parent’s location.
– If the mains power adapter is connected
correctly, the red CHARGE LED on the
recharging base lights up.
• Switch the receiver on to an acceptable
sound level (fig. 1.4) .
– If a sound signal is received from the
transmitter, it is heard via the built-in
speaker.
• Adjust the sound level as required.
Notes
– For baby monitoring make sure the
transmitter is in VOICE mode!
– Do not place transmitter and receiver too
close to each other while operating.
Otherwise the units will start resonating
(giving a high-pitch sound).