Philips SBC RU 865/00 - Manual (Page 7)

ENGLISH 7
Learn codes from original remote control
If your equipment is not included in the code list, or if specific codes on
your remote control are missing, the SBC RU865 has the solution. It can
copy and replicate codes from your original remote control. Here's how...
Place your original remote control facing the infra-red sensor window of
the SBC RU865. Place both remote controls on a flat surface,
3-8 centimetres apart.
Make sure that both remote controls have new batteries.
1 Press and hold SETUP until SETUP lights up in the display.
➜ DEV (first line)
➜ ADD (second line)
2 Use the Device Selection keys to select KEY.
➜ KEY (first line)
3 Use SMART CONTROLS to select LEARN.
➜ LEARN (second line)
4 Confirm with SEND.
➜ LEARN (first line)
5 Use SMART CONTROLS to select the device to be learned.
➜ TV (for example - second line)
The SBC RU865 is now in learning mode and the LCD displays the selected
equipment.
6 Confirm with SEND.
7 Press a learnable key on your remote.
(The keys below the part-line, Standby key, and the
SMART CONTROLS are learnable.)
➜ ORIGIN (second line)
8 Press the key on the original remote control you want to learn from.
➜ STORED (second line)
You have learned your SBC RU 865 a new code. If you want to copy more functions from your
original remote control, start again from step 7. Press SETUP to exit the menu.
Tip: Choose keys that correspond with the keys on your original remote control,
so that you can remember them easily.
If the SBC RU865 displays ERROR for a second, followed by ORIGIN the SBC RU865
did not receive the signal correctly. In this case you should:
•
Vary the distance slightly between both remote controls and try again from step
1 (try this several times).
• This time you should press and immediately release the function key on your
original remote control.The LCD should display STORED, indicating that the
RU865 received the signal.
• Make sure that both remote controls have new batteries.
• Try to copy your codes under different lighting conditions. Light from TL-tubes
may influence the signal you are copying.
The SBC RU865 is designed and tested extensively and is ready to copy almost all infra-
red remote control signals. In some rare instances manufacturers use infra-red signals that
cannot be copied to any remote control.You should of course always try the Autosearch
to see if such a code is included in our pre-programmed library.
Copy key functions
It is possible to copy key functions from keys in one device mode (e.g.TV mode) to keys
in another device mode (e.g. DVD mode) so you can operate different devices without
changing mode. For example: you can put the TV in Standby while being in DVD mode.
1 Press and hold SETUP until SETUP lights up in the display.
➜ DEV (first line)
➜ ADD (second line)
2 Use the Device Selection keys to select KEY.
➜ KEY (first line)
3 Use SMART CONTROLS to select COPY.
➜ COPY (second line)
4 Confirm with SEND.
➜ FROM (first line)
5 Use SMART CONTROLS to select the device you wish to copy key functions
from.
➜ TV (for example - second line)
6 Confirm with SEND.
XP SBC RU 865.1 15-08-2002 10:26 Pagina 7