Philips Remote Starter - Manual (Page 36)

EN-34
installation > Digital: Test reception.
Press
2.
Æ
to enter the Digital: Test reception
menu.
Press
3. OK.
Press the green key to automatically start the 4.
test or manually enter the frequency of the
channel you want to test. If the signal quality
and strength is poor, reposition the antenna
or satellite dish and retest.
When complete, press the yellow key to store
5.
the frequency.
Press the red key to return to the
6. Channel
installation menu.
Press
7. MENU to exit.
Note D
If you have further problems with the
reception of your digital broadcast, contact a
specialised installer.
6�8 Start a demo
Press the red key on the remote control. 1.
Alternatively, press MENU on the remote
control and select TV menu > Features
> Demo.
Press
2.
Æ
to enter the Demo menu.
Select a demo and press 3. OK.
Press the red key to exit. 4.
6�9 Reset TV to factory settings
Resetting your TV to factory settings restores
default picture and sound settings. Channel
installation settings remain the same.
Press 1. MENU on the remote control and
select TV menu > Installation > Factory
settings.
Press
2.
Æ
to enter the Factory settings menu.
Reset is highlighted.
Press
3. OK to reset to factory settings.
Press 4. MENU to exit.
Press 2.
Æ
to enter the Rearrange list.
Press 3.
Î
or ï to select the channel you
want to rearrange.
Press the yellow key to move the channel
4.
up the list. or press the blue key to move
the channel down the list.
Press
5. MENU to exit.
6�6 Manually update the channel
list
If your TV is in standby mode, an update is
performed every morning. This update matches
channels stored in your channel list with those
available from your broadcaster. If a channel is
unavailable, it is automatically removed from
the channel list.
In addition to the automatic update, you can
manually update the channel list.
Press 1. MENU on the remote control
and select TV menu > Installation >
Channel installation > Installation
update.
Press
2.
Æ
to enter the Installation update
menu. Start now is highlighted.
Press
3. OK.
Press the green key to start the update. 4.
This may take a few minutes.
When the update is complete, press
5.
the red key to return to the Channel
installation menu.
Press
6. MENU to exit.
6�7 Test digital reception
If using digital broadcasts, you can check the
quality and signal strength of digital channels. This
allows you to reposition and test your antenna or
satellite dish.
Press 1. MENU on the remote control and
select TV menu > Installation > Channel