Philips PET737/93 - Manual

TV
AUDIO IN
VIDEO IN
This portable DVD player is designed with a
built-in lithium battery to supply power to the
player when you are on travel.
1 Slide the POWER switch to the OFF
position (charging of the DVD player only
possible in the power-off mode).
2 Connect the supplied power adaptor cord (or
the car adaptor) to the player and AC mains (or
the car cigarette lighter outlet) to start charging.
➜ The CHG indicator turns red.
➜ When the battery is fully charged, the
indicator turns off.
3 Disconnect the power adaptor cord (or the car
adaptor) when the CHG indicator turns off.
Note:
– You can also connect the supplied power adaptor
cord (or the car adaptor) to the player and AC
mains (or the car cigarette lighter outlet) directly
wherever possible.
Charge your battery 1
Quick start guide
Philips Portable DVD Player PET737
3 OPEN HERE
1 Open the lid of the player.
2 Slide the POWER switch to ON to switch
on the DVD player.
➜ The POWER indicator turns on.
3 Press OPEN to open the disc door.
4 Remove the protective card (if any) and load a
disc with the label side facing up.
5 Close the disc door. Playback will start
automatically. If not, press 2;.
6 To stop playback, press 9.
2 Enjoy (Disc operation)
Note:
– Once the battery is fully discharged, immediately
recharge it (regardless of whether you plan to use
the battery or not) in order to maximize the
battery life.When the power is low, the battery
icon will be shown on the upper-right corner of the
TFT for warning.
2 Enjoy (AV OUT)
Connecting additional equipment (TV
for example)
1 Connect the AV OUT socket on the set to the
video and audio sockets on a TV as shown directly.
2 Switch on the TV and set to the correct
video-in channel.
➜ You can consult the owner's manual of your
TV. (If your TV does not have Audio and
Video inputs, you will need to purchase a
RF modulator. Please consult your dealer.)
Printed in China PDCC-ZYL-0813
White
Red
Yellow Not supplied
1 Connect the DVD player to the antenna as
shown.
2 In TV mode, press MENU.
3 Press
1, 2 to switch to PAL I.
4 In the TV menu, when AUTO SEARCH is
highlighted, press OK on the remote ( 2; on
the set).
➜ “AUTO SEARCH” is displayed.
➜ All available TV channels will be auto
searched and stored.
5 To stop searching, press MENU.
2 Enjoy (TV)
For details, seethe user manual.
PET737_QSG_Eng.qxd 2008.3.25 16:55 Page 1