English – Panasonic ES8164 User Manual

Page 4

Before use

This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
it in water. The following is the sym-
bol of Wet shaver. The symbol means
that hand-held part may be used in
a bath or shower.

Treat yourself to wet lather shaves
for at least three weeks and notice
the difference. Your Panasonic Wet/
Dry shaver requires a little time to get
used to because your skin and beard
need about a month to adjust to any
new shaving method.

Parts identification

(see fig. 1)
A Protective cap
B System outer foil
C Inner blades
D System outer foil release buttons
E Pivot action selector
F LCD display [ES8164]

LED display [ES8162]

G Battery capacity monitor

(ES8162)

H Charge status lamp (ES8162)
I On/Off switch
J Finger rest
K Trimmer
L Trimmer handle

M Adaptor
N Power cord
O Charging stand
P Soft case
READ ALL INSTRUCTIONS BE-
FORE USE.

Charging

Connect the power cord to the
shaver, and plug the adaptor into an
AC outlet. (see fig. 1 (A))
The shaver will be adjusted automati-
cally to voltages between 100-240V
AC.
In some areas, a special plug adap-
tor may be required.

• When charging the shaver for the

first time or when it has not been in
use for more than 6 months, the
plug symbol and backlight of LCD
display (ES8164) or charge status
lamp (ES8162) may not illuminate
for a few minutes after operation.
These lights will eventually illumi-
nate if kept connected.

Adequate ambient temperature for
charging is between 15 to 35

°C.

• If it is far below or over the appro-

priate temperature, the charging
time may be extended, or the adap-
tor may not function.

• In particular, low temperature may

shorten the life span of the re-
chargeable battery. In this case, the
backlight of LCD display (ES8164)
or charge status lamp (ES8162)
blinks twice in 1 second.