Palsonic 4910 User Manual
Page 6
3.2.2.4 Press PRESET ON/OFF button to exit preset mode.
The searched program station has been memorised at the present channel position,
3.2.2.5 Repeat 1~ 4 steps to search another channel.
NOTE : * If the same channel position is selected during repeat operation, the former
memory will be erased.
* If some channel position is tuned by MANUAL TUNING mode, AFC (automatic
frequency control) function is defeated in this channel position.
3.3 SKIP BUTTON
3.3.1 FUNCTION
When CHANNEL SELECTOR ( )button is used to select channel, the channels
will be skipped if they are set to "SKIP" mode. For example: Set 2~7 channels to
"SKIP" mode, the procedure of channel position increasing or decreasing is as
shown.
3.3.2 OPERATION:
3. 3.2.1 Press PRESET ON/OFF button to set preset mode.
3. 3.2.2 Select a channel by using CHANNEL SELECTOR button.
3.3.2.3 Press "SKIP" button, "SKIP" will be-displayed on the screen to indicate that the
channel is at "SKIP" mode.
3. 3. 2. 4 Repeat 2~3 steps to skip another channel.
3. 3. 2. 5 Press PRESET ON/OFF button to exit preset mode.
3.4 CHANNEL SELECTION
3.4.1 This set is preset to Australia channels 2, 7, 9, 10, 28 on those numbers. If you wish
to change the settings, or add more channels the method is quite straight forward.
3.4.2 Press CHANNEL SELECTOR ( )on the appliance, the channel number will be
increased or decreased as shown in the following Fig. , and displayed in the upper right
corner of the screen.
4
1 8 9 99 0
(REMOTE)
(THE APPLIANCE)
CHANNEL DECREASE
CHANNEL INCREASE
1 8 9 99 0
CH
CH
CH
3 SKIP
llllllllllllll
SKIP