Philips 7800XLCC User Manual
Page 11
ENGLISH
21
C
1
Connect the small plug to the Jet Clean
System. Connect the charging plug into
any 100V to 240V AC outlet. Use only the
charging plug provided.
The razor holder automatically moves up to the
highest position.
2
.
Place the Jet Clean System on a
flat, level surface. Fill the cleaning
reservoir with cleaning solution (see
‘Preparing Jet Clean System For Use’).
C
3
Remove protective razor head cap from
razor.
C
4
Place the razor head side down in the
razor holder so that the razor head fits
into the configuration shown inside the Jet
Clean System. Gently press the base of the
razor towards the back of the Jet Clean
System so that the razor base fits snugly in
place. Lock the razor into place by pushing
the lever down completely.
The charging light will blink to indicate the razor
automatically begins to charge.
C
5
Press the ON/OFF button to start the
cleaning cycle.
The cleaning light on the Jet Clean System starts
blinking and the razor is automatically lowered
into the cleaning solution.The razor stops
charging while it is cleaning.
ENGLISH
20
C
6
The amount of cleaning solution in the
transparent cleaning reservoir is visible on
both sides of the Jet Clean System. When
the level gets low, refill with Philips
Norelco HQ200 Cleaning Solution.
◗ The cleaning solution is automatically supplied
from the reservoir to the cleaning canister
through a special mechanism in the reservoir
cap.
C
7
Replace cap on reservoir (2) and turn
clockwise (1) making sure cap is screwed on
securely.
◗ The cleaning solution may foam if the reservoir
level is too low.Discard remaining solution,rinse
the reservoir with warm water from the tap and
refill with new cleaning solution.
◗ If you clean your razor every day, you should
refill the reservoir approximately once a
month.
C
8
Carefully lower the cleaning reservoir back
into the Jet Clean System making sure the
reservoir is properly aligned with the base
unit.
Jet Cleaning the Razor
◗ If the razor does not contain enough power
for one (1) shave, the Jet Clean Cleaning
System may not work properly. Charge the
razor in the Jet Clean System before using it
to clean your razor.