Philips HTS3400 - Manual (Page 32)

32
English
Tuner Operations
IMPORTANT!
Make sure the FM and AM antennas
are connected.
Tuning to radio stations
1
Press TUNER on the remote (or press
SOURCE control on front panel) to
select “
FM” or “AM.”
2
Press and hold
S / T on the
remote until the frequency indication
starts to change, then release.
➜
The next radio station will tune
automatically.
3
To tune a weak station, press
S / T
briefly and repeatedly until an optimal
reception is found.
Presetting radio stations
You can store up to 40 preset radio
stations in the memory, starting from FM
and followed by AM bands.
Automatic presetting
You can store all available radio stations
automatically.
●
In tuner mode, press and hold PROG
until "
AUTO PROG" appears.
AUTO PROG
➜
All the available radio stations with
strong transmission signal will be stored.
➜
Automatic preset will begin from
preset (1) and all your former presets will
be overridden.
➜
If it reaches 40 presets, “
PROG FULL”
appears.
➜
Once complete, “
PROG END” appears.
Manual presetting
You can choose to store only your
favourite radio stations.
1
Tune to your desired radio station (see
“Tuning to a radio station”.)
2
Press PROG.
➜
“
PROGRAM
” icon appears.
3
Use the numeric keypad (0-9) to
select a preset number.
➜
If “
PROGRAM
” icon goes off before you
select the desired preset number, press
PROG again.
4
Press PROG again to store.
5
Repeat steps
1
~
4
to store other radio
stations.
Helpful Hints:
– If you attempt to program more than 40
preset radio stations, “
PROG FULL”
appears.
– The system will exit presetting mode if no
button is pressed within five seconds.
Selecting a preset radio
station
●
Press 1 2 or use the numeric keypad
(0-9) to select a preset number.
➜
The preset number, radio frequency,
and waveband will appear.
Deleting a preset radio station
●
Press and hold Ç until “
PXX CLR”
appears.
➜
The current preset radio station will
be deleted.