PYLE Audio PWLB805 User Manual

Page 2

-2-

-3-

Parts:

Fig 1

Step1:Install the display

According to the Fig. 1, mount the

part-a to the back of the LCD . First

determine the right holes,which should

be level to each other, on the part-a

according to the holes in the back of
the LCD. Mount the part-a to the back
of the LCD by 4 bolts and washers (D).

Step1:Install the display

Carefully: Don't force the bolt to LCD
hole, avoiding damage to people and
instrument. Don't use electronics drill to fasten screw.

Step 2:Mount the part-b to the wall.(Wood stud, Brick, Solid Concrete and

Masonry wall mo-unting options are provided below)

Wood stud mounting
First determine the required position in the wall.Mark 4 locations at the wall
according to the holes in the

, according to the Fig 2a. Then

pre-drill 50mm (at l east) deep hole with a 3mm drill bit . Fix the
to the wall by bolt ( F ) , as the Fig 2b shows . Please note the hooks in the

is up.

Wall Plate(2)

Step 2:Mount the part-b to the wall.(Wood stud, Brick, Solid Concrete and

Masonry wall mo-unting options are provided below)

Wood stud mounting

Fig

Brick, Solid Concrete and Masonry wall mounting
After determine the required position in the wall, mark 4 locations at the
wall according to the holes in the

, then pre-drill 50mm ( at

least ) deep hole with a 11mm drill bit at the position of marks. Insert the
Wall anchor cover to every hole. Last fix the

to the wall by

bolt (F).Please note the hooks in the

is up.

Wall Plate(2)

Brick, Solid Concrete and Masonry wall mounting

Step 3 mount the LCD display to the part b in the wall

Lift the

against to the

with hole to hole, and

according to the Fig 3a.Then slide the part a to the slot of the part b, as the
Fig 3b shows.Then tighten the safety bolt.

Monitor Plate

Wall Plate(2)

Step 3 mount the LCD display to the part b in the wall

Description

4
4

Letter

Monitor Plate

Wall Plate

M4x12 bolt

M4x8 bolt

Safety bolt

Long bolt

Wall anchor

Qty

M5x12 bolt

M5x8 bolt

M5 washer

A,B,C,D