POLAR PWD2635W-1 - Manual (Page 6)

Dispensing Room and Cold Water
Place a glass under the spigot. For cold water, press the button downward until the desired
amount of water is dispensed. Before the KETTLE
* Feature is activated, the button dispenses
room temperature water. To dispense room water, press the button downward until the desired
amount of water is dispensed
(for hot water, see Dispensing Hot Water).
Temperature Setting
The water temperatures (hot and cold) are factory set and cannot be adjusted.
Dispensing Hot Water
NOTE: The KETTLE* feature button is designed to be recessed inside the cabinet.
The hot water (KETTLE * feature) dispensing system on this unit is designed to save energy and
money. Conventional hot water dispensing systems operate 24/7 regardless of water usage. The (on
demand) KETTLE
* feature activates the hot water system "only" when the KETTLE* feature button
is activated delivering steaming hot water in less than 3 minutes.
To dispense hot water, first press the KETTLE
* Feature activation button. The red indicator light will
begin flashing to indicate that the water heater is active. In approximately 3 minutes the set
temperature point will be reached and the red light will stop flashing and remain on. The water is
now ready to be dispensed; press down on the button until the desired amount of water is
dispensed, then release the button. If water is not immediately dispensed, the water will begin to
cool and the red light will shut off, requiring you to initiate another cycle.
Child Resistant Safety Switch
To prevent hot water from accidentally harming a child, the hot
water dispenser button has a safety switch on it. Slide the switch
to the left and push the button down to dispense hot water.
DANGER: The hot water is heated to approximately 201˚F / 91˚C.
Temperatures above 125˚F / 52˚C can cause severe burns from
scalding.
DO NOT ALLOW CHILDREN TO USE THE HOT WATER
DISPENSING BUTTON WITHOUT PROPER AND DIRECT
SUPERvISION.
CLEANING AND MAINTENANCE
Like most appliances, your water dispenser requires periodic maintenance for maximum efficiency
and performance and must be cleaned on a regular basis (i.e. every 4 months). To maintain a
hygienic environment within your water dispenser and prevent potential formation (growth) of
bacteria, we strongly recommend regular cleaning. A cleaning kit is available through our Customer
Service Department at
1-866-253-0447 or can be ordered on line at www.greenwayhp.com.
Child Resistant
Safety Switch
5