Porter-Cable 447k - Manual (Page 11)

11
LINE-OF-CUT INDICATOR
Line-of-cut indicator slots (Fig. 9), are provided at the front of the saw base.
The right slot is used to follow a line when making a 90° cut. The left slot is
used to follow a line when making a 45° cut.
BLADE WRENCH STORAGE
Blade wrench storage is provided in the bottom of the saw handle (see
Fig. 10). Position the handle end of the blade wrench into the storage slot
and push forward until seated.
INSTALLING SAWDUST EXHAUST NOZZLE
An exhaust nozzle is provided to direct sawdust away from operator and the
line of cut. This nozzle can be installed as follows:
1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Swing open exhaust cover (A) Fig. 11, and clean out any sawdust that
may have accumulated.
3. Insert nozzle in exhaust opening and push in until seated.
4. To remove, grasp nozzle where it enters exhaust opening and pull out.
CAUTION: Never direct sawdust toward the operator. To avoid
personal injury from flying sawdust, the exhaust cover should be
kept closed at all times the nozzle is not assembled. NEVER insert
foreign objects into exhaust opening.
Fig. 10
SIGHT THIS EDGE
FOR 45° CUTS
Fig. 9
SIGHT THIS EDGE
FOR 90° CUTS
VIEW FROM
OPERATOR’S POSITION
Fig. 11 Fig. 12
A
A
900003 - 04-09-02.qxd 4/18/02 7:41 AM Page 11