Perlick R24N - Manual (Page 8)

Form No. Z2288
Rev. 8.22.06
8300 West Good Hope Road • Milwaukee, WI 53223 • Phone 414-353-7060 • Fax 414-353-7069
Toll Free 800-558-5592 • E-Mail: [email protected] • www.Perlick.com
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Door Switching Instructions – Single Door Refrigerator
Tools Required
■ Large Flathead Screwdriver.
■ Regular Philips-head screwdriver.
■ Small Philips-head screwdriver
Left Hinged Door
Units are available from
factory mounted left or right.
Workboard units are avail-
able with left mounting only.
All doors may be changed by
customer.
Operations to Perform
NOTE: Changing
the door mount is
not advised if you
have a custom
wood overlay.
This may result in
having a handle
in an undesirable
location.
STEP 1:
Remove top hinge pin from assembly.
Carefully lift and tilt out door assembly
from the unit and set aside.
STEP 2:
Carefully remove hole plugs on right
side of unit. be careful not to
scratch unit. Top and bottom plugs
must be removed. Do not discard.
STEP 3:
Remove top and bottom hinge brackets from unit. Then
remove door closing insert and hinge pin from bottom
hinge bracket. See door bottom hinge assembly detail.
STEP 4:
Remove bottom hinge bracket to
allow you to remove the door closing
insert. Immediately replace hinge
bracket.
STEP 5:
Remove top hinge bracket to allow
assembly of door closing insert
removed in step 4. reassemble hinge
to door after installing the closing
insert.
Operation Notes
NOTE 1:
Lower left hinge
bracket rotates
180° and
becomes upper
right hinge
bracket.
NOTE 2 & 3:
Top left hinge bracket rotates 180°
and becomes bottom right hinge
bracket.
Bottom hinge pin and door closing
insert assemble to bottom right hinge
bracket.
NOTE 4: The hole plugs removed
earlier are to be inserted into the
vacant left door mounting holes. Do
not hit with hammer or damage may
occur. Use hammer handle or wood
block to push plugs into holes.
NOTE 5:
Door bottom on right mounted version was door top on
left mounted version. Before attempting to re-mount door
verify that: (1) The door handle will be on the outside of
door. (2) The door closing inserts are on the bottom. (3)
All screws are hand tightened, over tightening will dam-
age the unit.
STEP 1
STEP 5
STEP 4 STEP 3
STEP 2
NOTE 1
NOTE 2
NOTE 3
NOTE 5
NOTE 4
HINGE PIN
HOLE
PLUGS
HINGE
BRACKET
CLOSING
INSERT
BOTTOM
HINGE PIN
DOOR
HINGE
BRACKET
UNIT
HINGE
BRACKET
DOOR
CLOSING
INSERT
HINGE
PIN
HINGE
BRACKET
CLOSING
INSERT
HINGE
BRACKET