Parkside PHKP 500SE - Manual (Page 6)

7 GB/IE/CY
Introduction / Safety notes
© Technical details
Nominal voltage: 230 V~ 50 Hz
Nominal power: approx. 40 W (500 W)
Heating up time: approx. 4 min.
Protection class: II /
Safety notes
½
ATTENTION! Please read all the instructions
and advice. Failure to observe the instructions
and advice given below may result in electric
shock, fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND
INSTRUCTIONS IN A SAFE PLACE FOR FUTURE
REFERENCE!
1. Workplace safety
a) Keep your working area clean and
clutter-free. Untidy or poorly lit working
areas can lead to accidents.
b) Do not allow the device to become wet.
Do not operate it in a moist environment.
c) Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.
½
Children or persons who lack the
knowledge or experience to use the
device or whose physical, sensory or
intellectual capacities are limited must
never be allowed to use the device
without supervision or instruction by
a person responsible for their safety.
Children must never be allowed to play with
the device.
½
ATTENTION! This tool must be placed down
on its wire stand 6 when it is not being used.
2. Electrical safety
a) The mains plug on the device must
match the mains socket. The plug must
not be modified in any way. Do not
use an adapter plug with devices fitted
with a protective earth. Unmodified
plugs and matching sockets reduce the risk of
electric shock.
b) Avoid touching earthed surfaces such
as pipes, radiators, ovens and refrig-
erators with any part of your body.
There is an increased risk of electric shock if
your body is earthed.
c) Keep the device away from rain or
moisture. Water entering an electrical device
in creases the risk of electric shock.
d) Do not use the mains lead for
any purpose for which it was
not intended, e.g. to carry
the device, to hang up the device or to
pull the mains plug out of the mains
socket. Keep the lead away from heat,
oil and sharp edges. Do not touch the mains
lead if it becomes damaged or severed while
you are working, instead pull the mains plug
out of the mains socket immediately. Damaged
or tangled mains leads increase the risk of
electric shock.
e) When working outdoors with an elec-
trical power tool always use extension
cables that are also approved for use
outdoors. The use of an extension cable suit-
able for outdoor use reduces the risk of electric
shock.
3. Personal safety
a) Remain alert at all times, watch what
you are doing and always proceed
with caution. Do not use the device if
you are tired or under the influence of
drugs, alcohol or medication. One mo-
ment of carelessness when using the device can
lead to serious injury.