PYLE Audio PLD162 - Manual (Page 15)

15
GENERAL OPERATION
TURNING ON THE PLAYER
Press the POWER button on the front
panel to turn on the power. When the
unit is on, it will search the disc
automatically. If there is a disc in the disc
slot, the unit will start playback
automatically. Beside this, you should
turn on the monitor that is connected to
the player.
Note: The unit has screen saver function
(select “ON” in Screen Saver setup). If
the playback is stopped and there is not
any button operation in 5 minutes, it will
activate the screen saver funcation
automatically; when any button for DVD
function is pressed, the screen saver
function will release automatically.
Remote Sensor (IR)
Point the remote handset to the remote
sensor IR on the front panel. Receive
the signal from remote handset.
Loading a Disc
1. Insert the disc with printed side facing
up into the disc slot.
2. The player will start playback
automatically.
Ejecting a Disc
Press (EJECT) button on the front panel
or on the remote control to eject the disc.
FACEPLATE RELEASE
Press REL (
) button on the front panel
to detach the removable faceplate.
SOUND ADJUSTMENT
Press SEL button on the front panel of
the unit or on the remote control to
select the desired adjustment mode.
The adjustment mode will change in the
following order:
By rotating the VOLUME knob on the
front panel or VOLUME +/- buttons on
the remote control clockwise or
counter-clockwise , it is possible to adjust
the desired sound quality.
LOUDNESS
Press and hold BND/LOUD button on
the front panel for several seconds or
press LOUD button on the remote
control to reinforce the bass output.
Press BND/LOUD button on the front
panel for several seconds again or press
LOUD button on the remote control
again to release this function.
SET THE CLOCK
Press the DSP button on the front panel,
the clock is shown on the LCD display.
Then press SEL button on the front
panel or on the remote control shortly,
the hour will be flashing.
Then rotate the VOLUME knob on the
front panel or VOLUME +/- button on
the remote control to change hours. And
then press SEL button to confirm it.
Press SEL button again, the minute will
be flashing. Then you can change the
minutes according to the operation
described above.
Mute
Press MUTE button on the front panel or
MUTE button on the remote control to
mute down the sound instantly. Press it
again to resume sound output.
Volume Level Adjustment
Rotate VOLUME knob on the front panel
or press VOLUME +/- on the remote
control to increase or decrease the
volume level.
EQUALIZATION
Press EQ button shortly to turn on
equalization function and to select desired
audio mode. There are four kinds of mode
as belows:
SUBWOOFER
Press EQ (SW) button on the front panel
for several seconds to toggle sub-woofer
output. Press it for several seconds
again to release this mode.
MODE SELECTION
Press MODE button on the front panel
of the unit or MODE button on the
remote control to select among radio,
disc (DVD/VCD/CD/MP3) play mode and
AV IN mode.
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
FLAT CLAS POP ROCK
Disc slot Eject button