Suggested settings, Lay.it.down, Phunk.101 – Peavey 500 User Manual
Page 10
10
Pad OUT for passive
and IN for active
Hi-boost OUT
Low-cut OUT
Pad OUT for passive
and IN for active
Hi-boost IN
Low-cut OUT
lay.it.down
A good general setting for just laying down the groove!
phunk.101
Add just a little funk to your sound with these settings.
SUGGESTED SETTINGS
Below are some suggested settings that should give you a starting point in developing your own sound with the ProBass500.
Experiment. Play. The ProBass500 is a versatile amp and with some experimentation‚ you’ll find usable settings for every situation.
Note:
1
Select pad OUT for passive instruments and pad IN for active instruments.
2
Use the pre gain as a volume control. Remember to reduce the post gain if the clip indicator lights.
3
The more pre gain—the more grunge!
4
The master volume should be used to raise or lower the overall volume once the pre gain and tone settings have been set.
5
Always make sure the red clip indicator is not on. If it does start to light up‚ reduce the post gain control.
6
Set the low cut OUT for more grunge in the lows!