Components, Ty-wk5p1sw, Parts used to assemble the wall-hanging bracket – Panasonic TY-WK5P1SW User Manual
Page 3: Parts used for installation, Wall-hanging bracket (vertical mounting type)
3
English
TY-WK5P1SW
Wall-hanging bracket (Vertical mounting type)
Parts used to assemble the wall-hanging bracket
ヂ Base upper and lower
fittings
(2)
ッ Bracket base left fitting
(1)
ツ Bracket base right fitting
(1)
ヅ M5x10 screws for
assembling the
fixture
(4)
Parts used for installation
View of fully assembled fixtur
㇙ M8×24 Allen head
countersunk screws
(4)
㇜ Positioning stickers
(2)
㇚ Dished toothed washers
(4)
㇝ Long bolt for securing the unit (1)
㇞ Screw M6 x 50 for securing
the unit
(1)
㇛ Insulation spacers
(4)
㇟ Allen wrench (included tool)
(1)
Please note the following before proceeding with installation:
Ƈ The plasma TV unit which will be attached to the wall-hanging bracket consists of the display unit,
tuner unit and speakers.
Precautions for wall-hanging bracket fitting
Ƈ The wall-hanging bracket is for use in attaching a plasma TV unit to a vertical wall for viewing. Do not fit to
any surface other than a vertical wall.
Ƈ To ensure correct plasma TV performance and prevent trouble, do not fit at any of the following locations.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form.
Ƈ Fit using techniques suited to the structure and materials of the fitting location.
Ƈ Use commercially available screws with a nominal diameter of 6 mm (0.2 inches) that are suited to the wall
material (wood, steel frame, concrete etc.) you are fitting the bracket to.
Ƈ For the TV power supply plug, use a power supply outlet that can be reached easily.
Ƈ Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to
do this may cause heat to build up inside the plasma TV, resulting in malfunction.
Ƈ Spread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched
during the assembly and installation work.
Ƈ When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.
Ƈ Take sufficient care to ensure safety around you when performing the assembly and installation work or while
moving about during the course of the work.
Ƈ Do not install the Plasma TV underneath ceiling lamps (spotlights, halogen lamps, etc.). Otherwise, the
cabinet may be bent or damaged by high heat.
Components
[The images shown in this manual are for illustrative
purpose only.]