Philips HP1500 - Manual (Page 10)

ENGLISH 10
Digital audio formats
The device will recognize the following digital input signals:
–
Stereo LPCM with sample frequencies 44.1 kHz and 48kHz
– Dolby® Digital (AC-3), up to 5.1 channels
– DTS®, up to 5.1 channels
In case an invalid digital signal is detected - for example a digital MP3 data
stream - the ‘DIGITAL’ indication LED will be illuminated in red.
In case a valid digital signal is detected - for example a digital DTS data
stream - the ‘DIGITAL’ indication LED will be illuminated in green.
TO ENSURE YOU GET THE BEST PERFORMANCE FROM YOUR
DIGITAL HEADPHONE SYSTEM:
PLEASE READ THIS MANUAL CAREFULLY.
Important information
• Please read the following instructions carefully, and retain this booklet for
future reference. All the safety and operating instructions should be read
before using the digital headphone system.
• Check if the voltage indicated on the type plate (located at the bottom of
the set) corresponds to the local mains voltage before connecting to the
mains power supply.
• Remove the batteries from the headphone’s battery compartment and
from the base station’s charging compartment and disconnect the power
cable from the mains if the system is not in use for a long period.
• Prevent fire or shock hazard: do not expose this equipment to humidity,
rain, sand or excessive heat caused by heating equipment or direct
sunlight.
0912HP_EU 09-12-2003 12:12 Pagina 10