PYLE Audio PYLE Chopper Series PLA2230 - Manual (Page 6)

4
frequency response
output power @ 14.4v DC, 50Hz
RMS Power at @ 4 Ohms
RMS Power at @ 2 Ohms
RMS Power at @ 1.3 Ohms
Maximum Power Output
20 0W MONO
3 50W MONO
60 0W MONO
19 00W MONO
20 Hz-250 Hz ( -3dB)
input impedance 10K Ohms
Stiffly regulated PWM power supplies. MOSFET switches maintain
rated power over a wide range of battery voltages.
When the sub sonic selector switch is in "ON" mode, this filter control
permits continuously variable adjustment from 10 to 100Hz.
This control permits adjustment of the bass level up to an increase of
approximately up to 18dB.
Adjustable from 20Hz to 250Hz with a slope of 24dB per octave.This
allows for the adjustment of the upper point of the frequency bandwidth
and the respective subwoofer.
Adjustable from 15Hz to 40Hz with a slope of 24dB per octave.This allows
for the attenuation of frequencies that are mostly inaudible and cause
unnecessary strain on the amplifier.
Protection against thermal, overload and short circuit conditions.
This amplifier come complete with a compact remote GAIN CONTROLLER
which can be conveniently mounted on or under the dashboard of your
car.
power supplies
sub sonic control
bass boost level control
crossover low pass filter
high pass subsonic filter
protection circuitry
remote dash-mount gain control
input sensitivity
power supply voltage 14.4V DC Neg. Ground (10.5-16V)
dimensions (W x H x L)
mm
inches
2-4 Ohm min speaker lmpedance
20 A x 2
270 x 36 x 305
10.63 x 1.42 x 12
T.H.D
S/N ration
fuse
>90dB
0.1%
250mV~4V Adjustable
PLA-1200
features and specifications
MONO BLOCK AMPLIFIER PLA-1200