Philips AX1101/00Z - Manual (Page 4)

PLAYBACK INFORMATION
• If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded
properly, nF dISC is displayed. In that case, use FINALIZE on your CD-
recorder to complete the recording.
• If you want to play a CD-Rewritable (CD-RW), it takes 3–15 seconds for sound
reproduction to start once you have pressed 2;.
• Playback will stop if you open the CD lid.
• While the CD is being read, 1 -:- flashes in the display.
VOLUME AND BASS
Volume adjustment
Adjust the volume by using VOL
E.
Bass adjustment
• Press BASS to switch the bass enhancement on or off
y is shown if the bass enhancement is
activated.
PROGRAM MODE
PROGRAMMING TRACK NUMBERS
You can select up to 15 tracks to play in a program.
A single track may be played more than once in
the program.
1 While playback is stopped, select a track with
∞ or §.
2 Press PROGRAM to store the track.
y
PROGRAM lights; the track number
programmed and P, with the total number of
stored tracks, are displayed.
3 Select and store all desired tracks in this way.
4 Press 2; to start playback of your selected tracks.
y
PROGRAM is shown and playback starts.
• You can review the program by pressing PROGRAM
for more than 2 seconds.
yThe display shows all stored tracks in sequence.
Notes: – If you press PROGRAM and no track is selected, SELECt is displayed.
– If you try to store more than 15 tracks, FULL is displayed.
Clearing the program
• While playback is stopped, press
9 to clear program.
yCLEAr is displayed once,
PROGRAM
disappears, and the program is cleared.
Notes: – The program also will be cleared if you
– interrupt the power supply, or
– open the CD compartment lid, or
– if the unit switches off automatically.
MODE
PROGRAM
p /L IN E OU T
p /L IN E OU T
PLAYING A CD
This CD player can play all kinds of Audio Discs such as
CD-Recordables and CD-Rewritables. Do not try to play a
CD-ROM, CDi, VCD, DVD or computer CD.
1 Push OPEN 2 to open the CD compartment lid.
2 Insert an audio CD, printed side up, by pressing the
CD center onto the hub.
3 Close the player by pressing the lid down.
4 Press 2; to switch the player on and start
CD playback.
yThe current track number and the elapsed
playing time are displayed.
• You can pause playback by pressing 2;.
yThe time where playback was paused will flash.
• You can continue playback by pressing 2; again.
5 Press 9 to stop playback.
yThe total number of tracks and the total playing
time of the CD are displayed.
6 Press 9 again to switch off the player.
• To remove the CD, hold it by its edge and press the
hub gently while lifting the CD.
Note: If there is no activity, the unit will automatically
switch off after a while to save energy.
0
MODE
SELECTING A TRACK AND SEARCHING
Selecting a track during playback
• Briefly press
∞ or § once or several times to skip
to the beginning of the current, previous or next track.
yPlayback continues with the selected track, and
its number is displayed.
Selecting a track when playback is stopped
1 Briefly press
∞ or § once or several times.
yThe selected track number is displayed.
2 Press 2; to start CD play.
yPlayback starts with the selected track.
Searching for a passage during playback
1 Keep
∞ or § pressed to find a particular passage in
a backward or forward direction.
ySearching is started and playback continues at
low volume. After 2 seconds the search speed increases.
2 Release the button when you reach the desired passage.
yNormal playback continues from this position.
Notes: – During SHUFFLE, SHUFFLE REPEAT ALL, REPEAT
or while playing a program, searching is only
possible within the particular track.
PROGRAM
MODE
This product complies with the radio interference requirements of the
European Union.
Both the model number and production number are located on the
bottom of the set.