PYLE Audio PLCD95UM - Manual (Page 6)

24. USB CONNECTOR SOCKET
When you want to use the USB,first you insert the USB connect line into the USB
connectorsocket of thefront panel and then insert the USB appliance into the USB
port to play(See fig.1). (Its operation is similar to the Mp3 operation.)
When the USB appliance connect to the unit, the system star playing track of
the USB appliance automatically.
NOTE:
To prevent damage to the USB ,in the state of the USB playing not to pull out.
23.LOC
When in the radio mode,press it to select local or distance broadcast station
receive sensitivity .
SCAN BUTTON
Press it to scan up by one channel step with station detection. If a valid signal has
detected, the current frequency is blinked with in 5 seconds, then press it again to stop
scan and remain the current frequency; otherwise, the unit continue to scan up by one
channel step with station detection 5 seconds later.
NOTE: The SCAN button on the remote controller(for RC version only)
BASIC OPERATION
20.POWER BUTTON
Press it(more than 1 second) to turn off and short press to turn on the unit.
19.BAND/ID3:
During radio mode:Press it to select your desired radio band and the band which
is selected will be displayed on LCD.
During mp3 mode :Press search button to working Id3 as follow:
(depend on the disc used for Mp3)
File folder song artist album
21.FLASHING LED
If the front panel is not on the main unit, LED will be flashing.
22.RESET
RESET button is placed on the housing and must be activated with either a
ballpoint pen or thin metal object. The RESET button is to be activated for the
following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
Note: If press RESET button, the unit can't work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the socket on the back of the front panel.
5
(USB connect line)
USB Port
(Fig.1)