Philips DVD755/05 - Manual (Page 33)

English
Cleaning discs
Some problems occur because the disc inside the player
is dirty.To avoid these problems clean your discs regularly, in the
following way:
● When a disc becomes dirty, clean it with a cleaning cloth.Wipe the disc
from the centre out.
Caution: Do not use solvents such as benzine, thinner,
commercially available cleaners, or anti-static spray intended
for analog discs.
Diagnostic program
If the player is still faulty you can start the Diagnostic
Program in the player.
How does the Diagnostic Program work: you can operate the Diagnosis
Program by following the instructions step by step.
Instructions
1 Unplug the power cord of the player.
2 Press the OPEN/CLOSE and ; button simultaneously and keep them
pressed while you plug the player.
➤ On the display the message
BUSY appears together with a counter.
This counter indicates the termination of the test when zero is reached.
➤ After a few minutes the message on the local display changes over
from
BUSY to ERROR or to PASS .
➤ If the message
ERROR appears on the display, there is apparently a
failure in your player and your player should be repaired.
3 Consult your dealer or the Philips Customer Care Centre for the
nearest Service Repair Shop in your country. The phone number is given
in your warranty booklet.
4 If the message PASS appears on the display, there is apparently no failure
in your player, in this case the failure can be caused by incorrect
interpretation of the operating instructions or a wrong disc is used or
your player is not correctly connected.In this case you should consult
your dealer or the Philips Customer Care Centre for further assistance
in solving the problem.
5 If the problem remains, then go to point 3 of this instruction to find the
nearest repair shop.
6 Unplug the power cord of the player.
7 Replug the power cord in the AC outlet.
TRACK TITLE
TIME TRACK TOTAL
CHAPTER CD SHUFFLE
CHAPTER TITLE TRACK
V REPEAT -B A
OPEN/ CLOSE PAUSE STOP
PLAY
BEFORE REQUESTING SERVICE 33