Philips VRZ344AT - Manual (Page 45)

Multi-Channel Television Sound System (VRZ364 only) (cont’d) 45
To receive and record programs broadcast in second audio, follow steps 1 - 6. To receive and record a
program broadcast in stereo, make one of the connections shown, then follow steps 1 - 6.
7
Press the REC(ord)/OTR button to start recording.
6
Press the SPEED button to select the tape speed.
CH3 CH4
RF OUT
ANT.IN
AUDIO
VIDEO
IN OUT OUT R
L
CH3 CH4
RF OUT
ANT.IN
AUDIO
VIDEO
OUT OUT
R
L
IN
IN
1
Press the VCR button, then press the MENU button.
2
Press the PLAY 8 or STOP 9 button to select VCR SET
UP, then press the FF :/OK button.
3
Press the PLAY 8 or STOP 9 button to select
STEREO/SAP, then press the FF :/OK button to select
SAP or STEREO, whichever you prefer.
4
Press the EXIT/STATUS button.
5
Use the CH(annel) 8/9 buttons to select a channel.
If you have a Stereo and a Monitor TV,
use a video cable to connect the VCR’s
VIDEO OUT Jack to the TV’s VIDEO
IN Jack. Use audio cables to connect
the VCR’s AUDIO OUT Jacks to the
Stereo’s AUDIO IN Jacks.
OR, if you have a single-speaker
TV, use an RF coaxial cable to
connect the VCR’s RF OUT Jack
to the TV’s ANTENNA IN Jack.
• If you want to connect the VCR to a
Stereo TV, follow these steps.
1) Connect the antenna or cable
signal to the VCR’s ANT(enna) IN
Jack.
2) Use stereo audio cables to con-
nect the VCR’s AUDIO OUT Jacks
to the TV’s AUDIO IN Jacks.
3) Use a video cable to connect the
VCR’s VIDEO OUT Jack to the TV’s
VIDEO IN Jack.
• Make sure the TV and the Stereo (if
applicable) are in Line Input or
Auxiliary mode. Please refer to your
TV or Stereo owner’s manual for
details.
Helpful Hints
SELECT , 9 CHOOSE :/OK
A ON SCREEN MODE ON
TIMER REC SPEED MANUAL
VIDEO STABILIZER OFF
PICTURE NORMAL
AUDIO OUT HIFI
STEREO/SAP STEREO
TO END PUSH EXIT
SELECT , 9 CHOOSE :/OK
A VCR SET UP
TUNER SET UP
INITIAL SET UP
TO END PUSH EXIT
VRZ364/VRZ344 4/7/99 8:11 PM Page 45