Panasonic EW3002 - Manual (Page 5)

8 7
Inserting/Replacing Batteries
1. Grasp the battery cover and remove it to the left as shown in Fig. 2-a.
2. Insert two 1.5 V alkaline (AAA/LR03) batteries, observing the (+) and (-)
signs to ensure correct polarity.
3. Close the battery cover until it clicks into place (Fig. 2-b).
• Approximately 500 measurements can be taken with a new set of
Panasonic alkaline batteries (at an ambient temperature of 22°C
(71.6°F), pressurization of 180 mmH ).
Fig. 2-a Fig. 2-b
Notes:
• Do not mix old and new batteries.
• The batteries’ power output is impaired at low temperatures.
• The performance of the batteries included with the product may be
affected somewhat according to factors such as the amount of time past
since the date of manufacture.
1
2
S Y S .
m m H g
D IA .
m m H g
P /m in . R
On/Off Start
PR EC ISE L OG IC ™
PRECISE LOGIC
™
S Y S .
m m H g
D IA .
m m H g
P /m in . R
On/Off Start
3
Name and Function of Each Product Part
SY S. mm Hg DIA
. mm
Hg P/m
in.
R
On/Off
Start
Battery cover
Pressure cuff
Fig. 1
Start (On/Off) button
Hard carrying case
(Can be used as an armrest) R On/Off
Start
SYS.
mmH
DIA.
mmH
P/min.
Recall button
Display
When to Change Batteries
Change the batteries when the battery symbol
(Fig. 3) appears on the display or when no data
is displayed even when the On/Off button is
pressed.
CAUTION:
Do not throw batteries into a fire. Doing so
may result in an accident or explosion.
R On/Off
Start
SYS.
mmH
DIA.
mmH
P/min.
Fig. 3