POSIFLEX Business Machines TP-6000 SERIES - Manual (Page 22)

TP6000 USER’S MANUAL 4 - 6
CONNECTING CABLES
Connect the cables required to the appropriate connectors. Please make sure
that each connector has to be connected to the right port in the right orientation. Some
connectors have to be inserted till a click is heard such as the LAN connector, the
external FDD connector, the power connector and the cash drawer connector. It is
recommended to screw on the connector once it is inserted such as the external VGA
connector, the LPT port connector and the COM port connectors. If COM1 port is to
be used, you would have to take down the COM1 terminator that is already mounted
on the COM1 port. However, it is highly suggested not to use for any serial device
that does not provide proper handshaking signals such as a serial mouse in order to
keep cash drawer control function. Adjust the slack of each cable and close the cable
cover. Use the same latch key as when opening the cable cover but this time turn it
clockwise on both sides to secure the cable cover on the main unit. Adjust the tilt
angle of the main unit for best viewing effect in the application.
CAUTION: Before doing any insertion or extraction of the power plug, be sure
to pull always the outer sleeve of the plug backward to release the
internal latch. Failure to do this could damage the power plug. Such
damage is considered as an artificial destruction and is not covered
by the warranty.
INSTALLING CASH DRAWERS
When there is only one cash drawer to be installed, just connect the standard
cable CCBLA-180 that comes with the cash drawer to the right RJ11C jack (be
careful, not the adjacent one left for MODEM).
When there are two cash drawers to be installed, please purchase and use the
optional split cash drawer control cable CCBLA-238 for the purpose of controlling
two cash drawers in the TP6000 series. The CCBLA-238 has a 6 pole plug at one end
and two 8 pole plugs at the other. The 6 pole plug should be inserted in the connector
marked “CR” found in the rear compartment of the terminal. Each 8 pole plug should
be inserted into the connector marked “signal cable from POS Printer” at the rear of
one of the cash drawer. The cable lengths for the two 8 pole plugs are different. Use