PYLE Audio PLTV65R - Manual (Page 11)

11
OPERATION
REMOTE SENSOR
There is a remote sensor IR (10) on the
front panel. On the monitor, there is
another remote sensor IR (26) to
receive remote control signal. You can
point the remote control handset to IR
(10) (when the monitor doesn't stretch
out) or IR (26) (when the monitor
stretches out) and press function keys
on the remote control to control the TV
unit.
The unit is also connected to an
external remote receiver (See the
electrical connection diagrams on Page
7), and the function is the same with IR
(10) and (26).
Notes:
The external remote receiver is
placed near the monitor for the best
to receiver remote signal easily.
If the angle of the monitor from
vertical exceeds
20 (Especially the
distance exceeds 3m.), controlling
the TV through IR (10) or (26) cannot
get good effect. You are suggested to
use the external remote receiver.
LIQUID CRYSTAL DISPLAY
The LCD (4) can show the current state of
the unit.
6.5 inch TFT DISPLAY
When the monitor stretches out, the 6.5
inch color TFT display (5) can show the
current state of the unit.
RESET FUNCTION
Reset button (9) must be activated with
either a ballpoint pen or thin metal object.
The reset button is to be activated for the
following reasons:
Initial installation of the unit when all
wiring is completed.
All the function buttons do not
operate.
Error symbol on the display.
Note: When the monitor stretches out and
on the central viewing position,
activate the reset button (9), the monitor
will turn downward and draw in
automatically.
OPERATING WHEN THE MONITOR
NOT STRETCHING OUT
When the monitor doesn't stretch out,
the front panel of the unit is in state A
(see Fig.A), you can operate the unit
following the instructions below.
Sound mode selection
Press SEL button (6) on the front
panel or MENU button (45) on the
remote control to enter sound mode
then pres sTUNING / buttons
(13&14) or TUN/CH / buttons
(46) to switch between volume, bass,
treble, balance, fader, loud and
equalization mode.
When mode has not been adjusted
for several seconds, display returns
to previous display status.
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
EQ mode LOUD mode
Adjusting the volume
Press SEL button (6) or MENU button
(45) then press TUNING / buttons
(13&14) or TUN/CH / buttons (46)
to enter volume mode, and then adjust
volume level using VOLUME / buttons
(7&8) or VOL / buttons (47).
Adjusting the bass
In bass mode, adjust bass level using
VOLUME / buttons (7&8) or VOL /
buttons (47).
Adjusting the treble
In treble mode, adjust treble level using
VOLUME / buttons (7&8) or VOL /
buttons (47).
Adjusting the balance
In balance mode, adjust sound balance
between left and right speakers using
VOLUME / buttons (7&8) or VOL /
buttons (47).
Adjusting the fader
In fader mode, adjust sound balance
between front and rear speakers using
VOLUME / buttons (7&8) or VOL /
buttons (47).