Poulan 530163731 User Manual

Page 3

UNIT / MAINTENANCE SAFETY

Disconnect the spark plug before perform-
ing maintenance except carburetor adjust-
ments.

Look for and replace damaged or loose
parts before each use. Look for and repair
fuel leaks before use. Keep in good working
condition.

Replace trimmer head parts that are
chipped, cracked, broken, or damaged in
any other way before using the unit.

Maintain unit according to recommended
procedures.

Keep cutting line at proper

length.

Use only 0.080

(2 mm) diameter

Poulan

PRO

brand line.

Never use wire, rope,

string, etc.

Install required shield properly before using
the unit. Use only specified trimmer head;
make sure it is properly installed and se-
curely fastened.

Make sure unit is assembled correctly as
shown in this manual.

Make carburetor adjustments with lower
end supported to prevent line from contact-
ing any object.

Keep others away when making carburetor
adjustments.

Use only recommended

Poulan PRO

ac-

cessories and replacement parts.

Have all maintenance and service not ex-
plained in this manual performed by an au-
thorized service dealer.

FUEL SAFETY

Mix and pour fuel outdoors.

Keep away from sparks or flames.

Use a container approved for fuel.

Do not smoke or allow smoking near fuel or
the unit.

Avoid spilling fuel or oil. Wipe up all fuel
spills.

Move at least 10 feet (3 meters) away from
fueling site before starting engine.

Stop engine and allow to cool before re-
moving fuel cap.

Always store gasoline in a container ap-
proved for flammable liquids.

TRANSPORTING AND STORAGE

Allow engine to cool before storing or trans-
porting in vehicle.

Empty the fuel tank before storing or trans-
porting the unit. Use up fuel left in the carbu-
retor by starting the engine and letting it run
until it stops.

Store unit and fuel in area where fuel vapors
cannot reach sparks or open flames from wa-
ter heaters, electric motors or switches, fur-
naces, etc.

Store unit so line limiter blade cannot acci-
dentally cause injury. The unit can be hung
by the tube.

Store unit out of reach of children.

SAFETY NOTICE:

Exposure to vibrations

through prolonged use of gasoline powered
hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or ab-
normal swellings.

Prolonged use in cold

weather has been linked to blood vessel dam-
age in otherwise healthy people. If symptoms
occur such as numbness, pain, loss of
strength, change in skin color or texture, or
loss of feeling in the fingers, hands, or joints,
discontinue the use of this tool and seek med-
ical attention. An anti--vibration system does
not guarantee the avoidance of these prob-
lems. Users who operate power tools on a
continual and regular basis must monitor
closely their physical condition and the condi-
tion of this tool.

SPECIAL NOTICE:

This unit is equipped

with a temperature limiting muffler and spark
arresting screen which meets the require-
ments of California Codes 4442 and 4443. All
U.S. forest land and the states of California,
Idaho, Maine, Minnesota, New Jersey, Ore-
gon, and Washington require by law that
many

internal

combustion

engines

equipped with a spark arresting screen. If you
operate in a locale where such regulations ex-
ist, you are legally responsible for maintaining
the operating condition of these parts. Failure
to do so is a violation of the law. For normal
homeowner use, the muffler and spark arrest-
ing screen will not require any service. After
50 hours of use, we recommend that your
muffler be serviced or replaced by an autho-
rized service dealer.

LINE TRIMMER SAFETY

WARNING:

Inspect the area to be

trimmed before each use. Remove objects
(rocks, broken glass, nails, wire, etc.) which
can be thrown by or become entangled in line.
Hard objects can damage the trimmer head
and be thrown causing serious injury.

Use only for trimming, scalping, mowing and
sweeping. Do not use for edging, pruning or
hedge trimming.

Cut from your right to your left. Cutting on
left side of the shield will throw debris away
from the operator.

ADDITIONAL SAFETY RULES

FOR OPTIONAL ATTACHMENTS

WARNING:

For each optional at-

tachment used, read entire instruction manu-
al before use and follow all warnings and in-
structions in manual and on attachment.

WARNING:

Ensure handlebar is

installed when using edger or brushcutter at-
tachments. Attach handlebar above arrow on
safety label on the upper tube (engine end of
unit). If your edger or brushcutter attachment
does not include a handlebar, a handlebar ac-
cessory kit (#530071451) is available from
your authorized service dealer.

Handlebar