PNY P-DSA2-PCIE-RF - Manual (Page 17)

installation.
For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up to
Windows.
2. At the Found New Hardware Wizard, select No, not this time,
then click Next.
3. Insert the provided driver CD into your CD-ROM Drive, select
Install the software automatically (Recommended), and click
Next.
4. Accept the default entry, then click Next.
5. Click Finish.
6. Repeat steps 2-5.
7. Click Yes to restart to complete the installation.
For Windows® Vista
For New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents of
the PCI_IO\SiI3132\Driver\RAID\FLOPPY” folder, found on the
driver CD, onto a blank floppy disk then follow the directions below.
1. Setup the RAID Array prior to Windows installation.
Aug/07 MN2036400001 17